Sportdog Fence Collar Not Working

1 000 feet of wire 100 flags 1 transmitter and 1 collar receiver are included to keep your dog contained in a yard up to 1 1 3 acres.

Sportdog fence collar not working.

Remove the collar from your pet. With drytek technology for dogs 10 lb. It is important to make sure the battery life of your collar receiver is working. What to do if an invisible fence is not working.

The transmitter is powerful enough to cover up to 100 acres of land with the purchase of additional wire flag kits sdf wf and you can add an. If the test light flashes your collar is working and you should try check the following. The sportdog brand in ground fence system is a simple and cost effective alternative to a traditional fence. The power light is on the loop indicator light is off and the fence transmitter loop alarm is sounding.

Rechargeable collar not compatible with sdf 100a or sdf ct 7 levels of static stimulation with vibrate buzz tone beep warning collar is waterproof and submersible to 25 ft. The collar receiver and the remote transmitter do not seem to be corresponding with one another. The collar receiver does not seem to be turning on. The collar has to be held on top of the boundary wire to activate or it does not activate at the boundary at all.

The collar receiver is beeping but the dog is not responding to the stimulation. The collar receiver is beeping but the dog is not responding to the stimulation. We recommend setting a boundary width for the warning and stimulation zones to approximately 16 24 feet 8 12 feet on each side of the wire. Invisible fence systems protect your pets by keeping them in your yard.

Do not use sharp turns as this will cause gaps in your boundary. If the battery is low replace it with new ones. The collar receiver can be activated inside the house if the boundary wire runs along the outside wall of the house. Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system.

Make sure the static correction level on the receiver collar is set at 2 or above. The collar has to be held on top of the boundary wire to activate or it does not activate at the boundary at all. Because they use a hidden wire that transmits a signal to a collar worn by.