What Is The Easiest Way To Remove Carpet Staples

To remove them use a floor scraper.

What is the easiest way to remove carpet staples.

Remove the staples after that. One way to do this is to lift the carpet away from the floor as you cut. Ours seemed to be stapled by someone very determined and very drunk lots and lots of staples all over the place. On a concrete floor the carpet pad is often glued into place.

Tear out the padding under the carpet. On a concrete floor the pad is glued in place so big chunks of pad will remain stuck to the floor. When you ve torn off all the carpet and pad pull out all the staples with pliers. The very flat tip of the heavy duty office stapler will slide under carpet staples easily.

How do i avoid damaging the finish on the hardwood. If needed cut the carpet into manageable pieces with a razor knife and roll them into tubes before placing them into the trash can. The best way to remove the carpet pad is to fold it up. With a motion similar to using a push broom go around the entire room to slice off or yank out the staples with the scraper.

In this case use a floor scraper to remove the pieces of padding that remain stuck to the floor. How to dispose old carpet. Disposal of old stair carpets is best done in heavy duty trash bags. It also shows how to remove carpet pad staples easy https.

Use pliers to pull each staple from the subfloor image 2 then place staples into disposable plastic cup. Our were on the treads and the risers. Removing the carpet tacks and staples. Throw them away as you remove them to avoid accidentally stepping on them.

This video will show you the fastest way to remove staples from your floor when taking out carpet. The most time consuming step in the process is removing staples. However a set of pliers flathead screwdriver and a 6 in 1 painter s tool are helpful to have on hand too. Flooring installers don t use a cat s paw to remove staples after old carpet has been removed there are just too many of them.

It s usually laid in smaller sections and it s stapled along its edges. Tough spots might require a power oscillating tool. Use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go. If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife.

Use a crow bar to remove the tack strips. Stray staples and nails will be scattered throughout the material so continue wearing gloves. Hold the tool at about a 45 degree angle and slide it forcefully along the floor. Cut the pad into strips and roll it up just as you did with the carpet.